forbingo.blogg.se

Elite dangerous shield generator
Elite dangerous shield generator











The only disadvantage in this case would be a slight decrease to jump-range due to the module's greater mass.Īnaconda running a PSG with shields activating

elite dangerous shield generator

For traders, however, the Prismatic Shield generator might be a welcome upgrade since most freighters should be able to cope with the power draw, especially since a ship outfitted for trading usually reserves its largest internal compartments for Cargo Racks, which do not require power. Multipurpose ships equipped for combat usually have less severe power management issues and thus the capability to use a Prismatic Shield Generator in combat, although other modules may have to be downgraded to accommodate it depending on the ship. However, the Prismatic Shield Generator comes with twice the mass, significantly more power-draw, a higher price, and loyalty unlock requirements through Powerplay, which makes it less convenient to purchase as well as more difficult to use efficiently on most combat ships. This represents a 15-20% difference in shield strength between a Prismatic Shield Generator and a standard Shield Generator of the same class and rating. My next quiz question is are shield cells based on a percentage or a fixed number of MJ? If the latter is true, then the more Boosters you use, the less effective even the best Shield Cells will become.The Prismatic Shield Generator's shield strength is almost equal to the shield strength of a standard Shield Generator that is one class higher. My Fer-De-Lance with 5A Shield Generator, 6A Power Distributor and four 0B Shield Boosters will therefore take four minutes and three seconds to restore shields! With a 0A Shield Booster, the shields are raised to 150.6MJ so will then take 116 seconds to recharge on the same ship (19% longer). Until I’ve tested this theory, I cannot be certain, but it follows that the increase in shield from the boosters would make the recharge time increase based on your power distributor’s ability to fill it back up.Īs you can see, if this is correct, the Cobra with 4A Shields and a 3A Power Distributor should recharge in 97 seconds. In theory therefore, a 4E shield should take 104 seconds (93.58 / 0.9) to recharge.Ī class 3A Power Distributor pumps out 1.3 MJ/s, so the same shield with an A rated distributor should take 72 seconds. The default shield generator is a 4E with 93.58 MJ total strength. The value of 0.9 MJ/s on a 3E Power Distributor on a Cobra is the rate at which systems recharge shields.

elite dangerous shield generator

March 2015 CMDR-Arithon Beginners Guides (0)Īfter a bit more research I have found some of the theory behind shield recharging.













Elite dangerous shield generator